How to Build a Smok Pen
The Smok Pen is really a revolutionary vaporizing pen that allows for a write-to-write experience, even while you are abroad. This is because of the unique design of the pen. It has two tanks, one smaller compared to the other, that house the e juice and charged batteries. When the user really wants to write, he just places the pen into the smaller tank and places the ink in the chamber where it’ll be vaporized. He simply turns on the pen and writes as though he could be writing under a black mirror.
One of the biggest attributes of the Smok Pen is its ability to charge while it is on your desk. This is EightVape because the coils on the Smok Pen were created in a way to keep the e juice from dripping onto the table or anywhere else. This is because of the 0.3-ohm coil that’s placed inside the Smok Pen. The 0.3-ohm coil ensures that even the slightest of air currents will not affect the writing process. Simply because the electronic circuitry has protection built-in so that it will never be suffering from extremely low voltage electric currents.
The Smok Pen can be charged internally with a charger or via the USB connection that is included with it. Since the electronic circuitry includes a safety barrier built in, therefore there is absolutely no risk involved when charging the device through the computer. The Smok Pen has a charging capacity of sixteen 50 mah batteries, that is ideal for all pens that use a couple of batteries.
In order to keep the Smok Pen working for an extended time period it is important you don’t overcharge the battery. Overcharging the battery will certainly reduce the voltage that’s available and may eventually result in these devices malfunctioning. Overcharging the Smok Pen may also affect the vaporizing process. If you feel that your battery isn’t getting the vapor it should, remove the pen from the energy source and let it cool off for some minutes.
The fire button on the Smok Pen is located at the bottom right corner of these devices. The fire button comes with an orange light, which indicates that it’s on. You can press this button to activate the electronic heating element that may enable you to vaporize the oil. When you have done so you can take away the coil from the holder and stick it in to the holder and place the Smok Pen into the airflow chamber, which will cause the heating element to start out heating up and burning off the wick.
When the coil is taken off the holder the airflow chamber is ready for the sub-ohm cartridge. The coils are placed inside the holder and they get heated from the airflow. After they get hot they start to turn blue, which is the indication that it is ready for the pen’s battery. Ensure that you place your sub-ohm in to the chamber before you push the fire button. If you don’t put the coil into the airflow chamber then the oil will leak and cause the leaking of e-juice.
Before you put the battery in to the pen, you must make sure that you have disconnected all the leads. Then you have to take out the Smok Pen’s cap and locate the leak or drip tip. You need to clean this with a small cotton bud, so that you could eliminate the leak. Then reattach the cap back to the Smok Pen and you are prepared to place the battery in to the pen.
The ultimate the main construction process is the adapter plate, which fits in to the Smok Vaporizer’s USB port. This plate enables you to charge your e-juice through your computer, so long as you have an adapter for USB connection. I really like this part since it allows me to charge my entire kit simultaneously without worrying about running out of power or constantly running out of e-juice.